Intel Trace Analyzer and Collector

This is a thing that came as part of the Intel cluster toolkit on zero but I am still figuring out how to use it, sp these are rough notes.

module add itac
mpicc -trace -o foo foo.c
mpicc -tcollect -o foo foo.c # not sure what the difference is
itcpin -- foo 
mpiexec foo

The output is voluminous and rapidly causes the nodes to swap. You can filter it.

[cen1001@zero tracing]$ cat itac.conf 
MEM-FLUSHBLOCKS 256 # flush to disk once you have 16Mb of data
MEM-MAXBLOCKS 1024 # stop and flush if you have more than 64Mb
FLUSH-PREFIX /scratch/cen1001 # where to flush to
STOPFILE-NAME /home/cen1001/STOP # this doesn't work unless you use the failsafe libs

echo $VT_CONFIG 
/home/cen1001/src/NMM-MPI/tracing/itac.conf

qsub -v PATH,LD_LIBRARY_PATH,VT_CONFIG run.sh

traceanalyse